Sunday, June 14, 2020

3D Printing part II

         I have been printing off some free legion stl. I got the assault marines to come out ok. The heavy support were more troublesome. I don't use auto supports. Sometimes I run a support through a dude or it is too close. Legs got lost, jet packs were not fully supported. Some of the heads were not coming out.

           I also chose my rotation angle. Or I did. A youtube dude said prusa slicer is great for rotation. The prusa slicer does a perfect job selecting the best rotational angle for printing. It is all I use it for.

         After about a month and a half the film started to cloud. I replaced the film and releveled.
 There are a million little screws.





No comments:

Post a Comment